Your water heater is one pretty used and more appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving around the home heating and energy costs.

Regular flushing of your water heater is probably the single most important step you consider to prolong its service life this particular save energy. Over a period of time, sediments amass in the bottom of your hot water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. In part destructive to the tank, but highly inefficient and will significantly raise your heating costs.

In most associated with the country, the typical water heater lasts 3-5 years. Regularly flushing your hot water heater can double existence of your water heater from 3-5 to 7-10 years. And with the costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater ‘s very important in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of drinking water your home uses, that can mean a savings of $20 to over $50 a fair amount of time.

To drain your water heater, first you should set the thermostat to pilot (if it can be a gas water heater) or turn the circuit breaker off (if it is electric heater). Failure to do so could result in overheating and severe damage to drinking water heater. Next, close the water supply valve located over the water inlet line going into your water heater. You can then connect a garden hose to the drain valve located at the bottom of the heater tank. Open the drain and allow it to function until all for the water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until the water flows out gradually. This will allow air to vent via the heater and the water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).

Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system home to filter or condition the water so may be less corrosive to your plumbing system, particularly in areas which have hard this type of water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your neighborhood to discuss options and products to suit your needs.

Abacus Plumbing, Air Conditioning & Electrical

The Woodlands, TX

(281) 528-1610

https://goo.gl/maps/Fccz1JjKrjN2